スキャナー Fujitsu SP10CのPDF インストール手順マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu SP10C 9 ページ。 Scsi scanner installation procedures for windows nt 4.0
Fujitsu SP10C にも： インストール手順マニュアル (7 ページ)
ページを印刷する
Fujitsu SCSI Scanner Installation Procedures
If you are installing the following models by means of the SCSI interface then use this
document.
SP10C
SP15C
SP600C
SP620C
SP3091DC
SP3092DC
SP93GX
If you are going to use the USB interface of a dual SCSI/USB model then use the USB scanner
installation guide. For Scansnap models please use the Scansnap installation guide.
Hardware requirements.
You will need a PC system that meets our recommended specifications, an appropriate SCSI
controller, and a SCSI cable (six foot recommended maximum). For recommended PC system
specifications and SCSI controllers please reference the
You may also need your Operating System Disk.
Step A: Installing the SCSI Host Adapter (Adaptec).
1. Shut down your PC and remove the case cover.
2. Locate a free PCI slot and remove the back plate if necessary.
3. Install the SCSI controller in an open PCI slot.
Make sure that the card is seated completely in the slot and secured in the frame
Warning! Failure to secure the SCSI controller in the PC can result in damage to the
SCSI card, scanner, and/or your system.
4. Boot your PC without the scanner attached
Step B: Installing the SCSI drivers (Adaptec).
Although Windows NT has driver support for your host adapter it does not support plug and
play. Therefore the SCSI drivers will need to be loaded manually. Follow the instruction below
to install the driver for your host adapter.
Rev051906A
Windows NT 4.0
M3093GX\DG
M3096GX
M3097G\G+\DG
M3099G\GX\GH
FI-4120C\C2
Fi-4220C\C2
Fi-4340C
Fi-4530C
Fi-4640S
M4097D
Fi-4750C\L
M4099D
Fi-4860C
Fi-4990C
Scanner Hardware Reference
.
Fi-5120C
Fi-5220C
Fi-5530C
Fi-5650C
Fi-5750C
Fi-5900C
page.
Page 1 of 9