- ページ 2

プリントサーバー Brother HL-4070CDWのPDF サービス・アップデート・マニュアルをオンラインで閲覧またはダウンロードできます。Brother HL-4070CDW 11 ページ。 Brother color laser printer
Brother HL-4070CDW にも：パンフレット (4 ページ), 部品リファレンスリスト (40 ページ), クリーニングとケア (7 ページ), サービスマニュアル (13 ページ)

ページを印刷する

Step 2: Check the Belt Cleaner Release Assembly

A. To check the assembly with all the supplies removed. Locate the Belt Cleaner Release Assembly (Figure

3).

B. Verify that the assembly is completely flush with the printer frame. The assembly is attached to the printer

frame with small pegs (Figure 5). If the pegs are not aligned properly, the assembly may not be flush with

the print frame. If the assembly is not flush, reseat the assembly as needed.

C. There is an actuator location on the back of the belt cleaner release assembly (Figure 4). It is an actuator

that can be pressed down. Verify the actuator is moving smoothly by pushing down on the actuator.

Repeat the test at least 10 times. The actuator should move smoothly and return to the UP position

when finger pressure is removed from the actuator. The sensor that this actuator activates (belt cleaner

release sensor) can be checked using maintenance mode 32. See Chapter 5 Service Functions in the

service manual.

If the actuator is sticking or does not move freely we recommend you clean the assembly

II.

If the actuator still does not move freely or the belt cleaner release sensor fails

maintenance mode 32 test, then replace the belt cleaner release assembly. Refer to

Service Update F1249 (No Paper Fed – Clicking Noise) for removal and replacement

instructions

Print Unable 2A or No Waste Toner error

HL4040CN, HL4040CDN, HL4070CDW

August 6th, 2013 v3

Page 2 of 11

SERVICE

UPDATE No.

Figure 3

P1292_EN