- ページ 22
ストレージ Fujitsu ETERNUS DX200 S3のPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu ETERNUS DX200 S3 28 ページ。 Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX200 S3 にも： 設定マニュアル サーバー接続 (12 ページ), 設定マニュアル サーバー接続 (12 ページ), 設定マニュアル (13 ページ), 設定マニュアル (18 ページ), セットアップマニュアル (15 ページ), 安全上のご注意 (12 ページ)
ページを印刷する
Chapter 7
Checking Connections
7.1
Turning on the Devices
To turn on the connected devices, use the following procedure:
1
Turn on any devices (such as LAN switches) on the LAN path between the ETERNUS DX and server.
2
After checking that the Ready (or equivalent) LED of the LAN switch is lit, turn on the ETERNUS DX
storage systems.
3
After checking that the ETERNUS DX's Ready LED is lit, turn on the server.
7.2
Setting Up the Server to Recognize the Logical Units
Make the server recognize the logical units (LUN) set in the ETERNUS DX storage systems.
1
Use the "ioscan" command to check which devices are connected.
Enter as follows for LegacyView (old format) results:
# ioscan -fn
Enter as follows for AgileView (HP-UX11iv3 and newer format) results:
# ioscan -fnN
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (iSCSI) for HP-UX
22
Copyright 2014 FUJITSU LIMITED
P3AM-3402-14ENZ0