- ページ 5

ストレージ Fujitsu ETERNUS DX200 S3のPDF セットアップマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu ETERNUS DX200 S3 15 ページ。 Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX200 S3 にも：設定マニュアルサーバー接続 (12 ページ), 設定マニュアルサーバー接続 (12 ページ), 設定マニュアル (28 ページ), 設定マニュアル (13 ページ), 設定マニュアル (18 ページ), 安全上のご注意 (12 ページ)

Install and fasten the high-density drive enclosure in the rack, and then attach the front cover.

Attach the cable management arm in the rear.

M5 screws

Front cover

(Rack pillar: front)

IMPORTANT

Cable Connection

STEP

Various cables need to be connected to the ports on the rear of the ETERNUS DX.

Configuration Guide (Basic)

●

Point

●

IMPORTANT

●

FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Setup Guide

M5 screws

For safety and stability, use a lifter to install or remove high-density drive enclosures in the rack.

To help with cable management and prevent incorrect connection, attach labels to the cables and make a

note of connection origins and destinations.

This step describes dual controller type as an example. Note that there is only controller 0 (CM#0) for single

controller type.

The cables should never be bent, twisted or pulled.

Some cables have static-sensitive electronic components. Wear an anti-static wrist strap or touch a metal

part to discharge the static electricity on your body before starting each operation. Failure to discharge static

electricity before touching the connectors may cause a device failure.

(Rack pillar: rear)

Cable

management arm

P3AM-7852-06ENZ0