- ページ 10

ストレージ Fujitsu GP5-HDH97のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu GP5-HDH97 14 ページ。
Fujitsu GP5-HDH97 にも：ユーザーマニュアル (10 ページ)

1 Setting the Drive

The drive number (SCSI ID) of this product is automatically set by the system.

No settings for terminator are required for this product.

2 Notes on Handling

CAUTION

The hard disk is a precision device. Strictly observe the following when handling the prod-

uct; otherwise, the product and/or the data in the disk may be destroyed.

Do not touch the connector section and the component installation surface of the PC

board when handling the product.

Be sure not to drop or mishandle the product in any way until the bottom of the product

completely touches the desk surface when the product is to be placed on the desk.

Before removing this product, turn off the power and wait until the disk completely stops

rotating (about 30 seconds).

To remove or install the product without turning off the power, carry out the procedures

described in the user's guide included with the mainframe of teamserver series.

Do not use or store the product in the following locations:

– Near a magnet or strong magnetic field

– Near a heater or location where the product would be exposed to direct sun light

– Any location subject to extreme temperature or humidity changes

– Any wet or dusty location

– Any location subject to vibration or shock

Do not disassemble the product.

3 Before Using the Hard Disk Unit

Before using this product, perform the required settings by referencing the included re-

●

lated hardware and software manuals.

To remove or install the product, carry out the procedures described in the user's guide

●

included with the mainframe of teamserver series.

Carry out the same procedures as described in the guide, though the defferent product

names are described in it because of the time when purchasing the mainframe.

This product temporarily make a noise right after power-on, but there is no problem with

●

its quality.