ページを印刷する
4
www.aeg.com
The appliance can be installed as freestanding or
•
below the kitchen counter with correct space (Refer to
the Installation leaflet).
Do not install the appliance behind a lockable door, a
•
sliding door or a door with a hinge on the opposite
side, that would prevent the appliance door from
being fully opened.
The ventilation opening in the base must not be
•
covered by a carpet, mat, or any floor covering.
WARNING: The appliance must not be supplied
•
through an external switching device, such as timer, or
connected to a circuit that is regularly switched on and
off by a utility.
Connect the mains plug to the mains socket only at
•
the end of the installation process. Make sure that the
mains plug is accessible after installation.
Ensure good air ventilation in the located room to
•
avoid the backflow of unwanted gases into the room
from appliances burning gas or other fuels, including
open fires.
If the mains power supply cable is damaged, it must
•
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
Do not exceed the maximum load of 8 kg (refer to the
•
"Programme chart" chapter).
Do not use the appliance if items have been soiled
•
with industrial chemicals.
Wipe away lint or packaging debris that has
•
accumulated around the appliance.
Do not run the appliance without a filter. Clean the lint
•
filter before or after each use.
Do not dry unwashed items in the tumble dryer.
•
Items that have been soiled with substances such as
•
cooking oil, acetone, alcohol, petrol, kerosene, spot
removers, turpentine, waxes and wax removers should
be washed in hot water with an extra amount of
detergent before being dried in the tumble dryer.