- ページ 17

冷蔵庫 AEG 6000 SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG 6000 Series 24 ページ。
AEG 6000 Series にも：ユーザーマニュアル (12 ページ), ユーザーマニュアル (24 ページ), ユーザーマニュアル (24 ページ)

ページを印刷する

Problem

Water flows on the rear plate

of the refrigerator.

There is too much con-

densed water on the rear

wall of the refrigerator.

Water flows inside the refrig-

erator.

Water flows on the floor.

Temperature cannot be set.

The temperature in the ap-

pliance is too low/too high.

Possible cause

Food products are not wrap-

ped properly.

Temperature is set incorrect-

ly.

Appliance is fully loaded and

is set to the lowest tempera-

ture.

Temperature set in the appli-

ance is too low and the am-

bient temperature is too

high.

During the automatic de-

frosting process, frost melts

on the rear plate.

Door was opened too fre-

quently.

Door was not closed com-

pletely.

Stored food was not wrap-

ped.

Food products prevent the

water from flowing into the

water collector.

The water outlet is clogged.

The melting water outlet is

not connected to the evapo-

rative tray above the com-

pressor.

The "Coolmatic function" is

switched on.

The temperature is not set

correctly.

The door is not closed cor-

rectly.

ENGLISH

Solution

Wrap the food products bet-

ter.

Refer to "Control Panel"

chapter.

Set a higher temperature.

Refer to "Control Panel"

chapter.

Set a higher temperature.

Refer to "Control Panel"

chapter.

This is correct.

Open the door only when

necessary.

Make sure the door is closed

completely.

Wrap food in suitable pack-

aging before storing it in the

appliance.

Make sure that food prod-

ucts do not touch the rear

plate.

Clean the water outlet.

Attach the melting water

outlet to the evaporative

tray.

Switch off "Coolmatic func-

tion" manually, or wait until

the function deactivates au-

tomatically to set the tem-

perature. Refer to "Coolmat-

ic function" section.

Set a higher/lower tempera-

ture.

Refer to "Closing the door"

section.