- ページ 21
冷蔵庫 AEG 6000 SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG 6000 Series 24 ページ。
AEG 6000 Series にも： ユーザーマニュアル (12 ページ), ユーザーマニュアル (24 ページ), ユーザーマニュアル (24 ページ)
ページを印刷する
Problem
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
DEMO appears on the dis‐
play.
A
or
or
symbol is
shown instead of numbers
on the temperature display.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Possible cause
The "Frostmatic function" or
"Coolmatic function" is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The door has been opened
often.
The Frostmatic function is
switched on.
The Coolmatic function is
switched on.
There is no cold air circula‐
tion in the appliance.
The appliance is in demon‐
stration mode.
Temperature sensor prob‐
lem.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
ENGLISH
Solution
Switch off "Frostmatic func‐
tion" or "Coolmatic function"
manually, or wait until the
function deactivates auto‐
matically to set the tempera‐
ture. Refer to "Frostmatic
function" or "Coolmatic func‐
tion" section.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door"
section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Refer to "Frostmatic func‐
tion" section.
Refer to "Coolmatic function"
section.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to "Hints and
Tips" chapter.
Keep the OK key pressed for
approximately 10 seconds
until a long sound is heard
and the display turns off for
a short time.
Contact the nearest Author‐
ized Service Centre (the
cooling system will continue
to keep food products cold,
but temperature adjustment
will not be possible).
21