- ページ 20

ソフトウェア Brother 2のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Brother 2 39 ページ。 Hewlett-packard laser printer user guide
Brother 2 にも：ユーザーマニュアル (15 ページ)

After cutting off the material, confirm the instructions,

and then touch the "OK" key.

To feed out the cut-off material, touch the "OK" key.



The cut-off material feeds out from the back of the machine.

Remove the leader sheet from the material.

Note

• When not using the leader sheet, remove any material such

as cutting scraps from the adhesive surface, attach the

protective sheet and store the leader sheet.

Trial Cutting

Perform trial cutting or drawing on the type of material to be

used in your project, to check that the desired result can be

achieved. This section describes the procedure for performing

trial cutting.

Touch the "Test" key in the cutting screen.



A test pattern is automatically arranged in the test screen.

Make sure that the test pattern does not overlap the

pattern for your project. To reposition the test pattern,

touch

. The test pattern can also be moved by

dragging it in the screen.

a Change the pattern arrangement.

Touch to make adjustments in the editing screen when

changing the arrangement of the pattern.

If changes are applied to the pattern arrangement, the

pattern will be automatically arranged in the same location

the next time trial cutting is performed.

b Touch to adjust the pattern shape and size.

If changes are applied to the pattern shape and size, the

pattern will be automatically arranged with the same shape

and size the next time trial cutting is performed.

Memo

• As a default, the test pattern is arranged in the upper-left

corner of the cutting area.

• In order to check the result of trial cutting while leaving the

material fed in, the test pattern must be arranged lower

than the default location.

a Top edge of cutting area

b Line where trial cutting pattern is arranged as a default

c Test preview screen