- ページ 32
ソフトウェア Brother DCP-130CのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Brother DCP-130C 47 ページ。 Windows vista
Brother DCP-130C にも： 仕様書 (2 ページ), クイック・セットアップ・マニュアル (22 ページ), クイック・セットアップ・マニュアル (22 ページ), セットアップマニュアル (23 ページ), クイック・セットアップ・マニュアル (24 ページ), クイック・セットアップ・マニュアル (15 ページ)
ページを印刷する
Error messages
Error Message
Cause
The machine has a mechanical
Change Unable
problem.
XX
—OR—
A foreign objects such as a clip or
ripped paper is in the machine.
The machine has a mechanical
Clean Unable
problem.
XX
—OR—
A foreign objects such as a clip or
ripped paper is in the machine.
The scanner cover is not closed
Cover is Open
completely.
Print data is left in the machine's
Data
memory.
Remaining
Print data is left in the machine's
memory. The USB cable was
unplugged while the computer was
sending the data to the machine.
The print head is too warm.
High
Temperature
The machine has a mechanical
Init. Unable
problem.
XX
—OR—
A foreign objects such as a clip or
ripped paper is in the machine.
One or more of the ink cartridges is
Ink Empty
empty. The machine will stop all
print operations.
The print head is too cold.
Low
Temperature
The media card is either corrupted,
Media Error
improperly formatted, or there is a
problem with the media card.
One or more of the ink cartridges
Near Empty
are running out of ink.
An ink cartridge is not installed
No Cartridge
properly.
The media card in the media drive
No File
does not contain a .JPG file.
28
Action
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, disconnect the machine from the
power source for several minutes then
reconnect it.
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, disconnect the machine from the
power source for several minutes then
reconnect it.
Lift the scanner cover and then close it again.
Re-start printing from your computer.
Press Stop/Exit. The machine will cancel the job
and clear it from the memory. Try to print again.
Allow the machine to cool down.
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, disconnect the machine from the
power source for several minutes then
reconnect it.
Replace the ink cartridges. (See Replacing the
ink cartridges on page 32.)
Allow the machine to warm up.
Put the card firmly into the slot again to make
sure it is in the correct position. If the error
remains, check the media drive by putting in
another media card that you know is working.
Order a new ink cartridge.
Take out the ink cartridge and put it in again
seating it properly. (See Replacing the ink
cartridges on page 32.)
Put the correct media card into the slot again.
B