- ページ 8

冷蔵庫 AEG FRIDGE-FREEZERのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AEG FRIDGE-FREEZER 10 ページ。 Aeg fridge-freezer
AEG FRIDGE-FREEZER にも：取扱説明書 (10 ページ), ユーザーマニュアル (28 ページ)

ページを印刷する

Defrosting

Frost is automatically eliminated from the

evaporator of the refrigerator compartment every

time the motor compressor stops, during normal

use. The defrost water drains out through a trough

into a special container on the back of the appliance

where it evaporates.

Periodically clean the defrosting water drainage hole of

the refrigerator, using the special cleaner already

inserted into the discharge hole.

D037

The freezer compartment, however, will become

progressively covered with frost. This should be

removed with the special plastic scraper provided,

whenever the thickness of the frost exceeds 4 mm.

During this operation it is not necessary to switch

off the power supply or to remove the foodstuffs.

However, when the ice becomes very thick on the

inner liner, complete defrosting should be carried

out and it is advisable to carry out this operation

when the appliance is empty.

To carry out complete defrosting of the freezer

compartment (

Unplug the appliance from the power supply or set

the thermostat on the «O» position. Remove the

ice-cube trays and the frozen foods and wrap them

in several sheets of newspaper or, even better, in

thermally insulated containers, and then keep them

in a cool place.

Keep the freezer door open and introduce a

container ﬁlled with hot water (taking care to place

this on a layer of cardboard) so as to accelerate the

defrosting process.

Fig. 10

) proceed as follows:

Place a basin on the ﬁrst grill shelf in the

refrigerator directly below the drainage hole and

lift up the small lid.

PR116

Absorb all remaining water with a sponge and then

accurately dry the freezer. Reconnect the appliance

to the power supply and then set the thermostat to

the coldest position for approximately 2 hours and

then shift it into the normal functioning status.

Replace the foods previously removed from the

freezer and the ice cubes trays.

Important

Do not use a mechanical device or any artiﬁcial

means to speed up the thawing process other than

those recommended by the manufacturer.

Remember that an increase in the surface

temperature of already-frozen foods may

signiﬁcantly decrease the duration of their

conservation.

Ice-cube production

This appliance is equipped with trays for the

production of ice-cubes.

Fill these trays with water to 3/4 of their height,

then put them in the freezer compartment.

The ice-cubes may be shaken out from the trays by

simply twisting; do not use metallic instruments to

remove the trays from the freezer.

Fig. 11