- ページ 19

プリンター Fujitsu FI-6230のPDF はじめにをオンラインで閲覧またはダウンロードできます。Fujitsu FI-6230 23 ページ。 Color duplex workgroup scanners
Fujitsu FI-6230 にも：スタートマニュアル (20 ページ), パンフレット＆スペック (2 ページ), 取扱説明書 (10 ページ), クリーニングとメンテナンス (47 ページ)

ページを印刷する

Appendix1

■ Troubleshooting checklist

Symptom

Scanner does not turn on.

Scanning does not start.

fi-6140/fi-6240/fi-6130/fi-6230 Image Scanner Getting Started

TROUBLESHOOTING

Check this item

Have you pressed the power button on?

Are the AC cable and AC adapter

properly connected to the

scanner?

Is Windows normally started up?

Are the documents loaded correctly on the

ADF paper chute?

Is the ADF closed completely?

Is the USB cable or SCSI cable properly

connected?

(When using SCSI interface) Is SCSI ID

set correctly?

Does the Function Number Display

indicates an alarm or an error?

Does the alarm state remain displayed

even after the scanner has been turned off

and back on again?

Push the power button.

Correctly connect the AC cable and the AC adapter.

Disconnect the AC cable and the AC adapter from

the scanner, then connect them again.

If this does not restore the power supply, contact

the store where you purchased the scanner or an

authorized FUJITSU scanner service provider.

Push the power button again after completely

starting up Windows.

Load the document correctly on ADF paper chute.

Close the ADF completely.

Correctly connect the cable. (When a USB hub is

used, check the hub's power supply.)

Set SCSI ID correctly by SCSI ID switch on rear of

scanner.

When the Function Number Display indicates an

alarm or an error, refer to chapter 6 "Troubleshoot-

ing" of "fi-6140/fi-6240/fi-6130/fi-6230 Operator's

Guide" for removing the alarm or the error.

Turn off and on the power button.

If this does not eliminate the alarm state, contact the

store where you purchased the scanner or an

authorized FUJITSU scanner service provider.

AP-1

Remedy