プリンター Fujitsu fi-6670 SeriesのPDF インストール手順マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu fi-6670 Series 6 ページ。 Image scanner
Fujitsu fi-6670 Series にも：ユーザーマニュアル (26 ページ), パンフレット (2 ページ), 仕様 (2 ページ), スタートマニュアル (14 ページ), スタートマニュアル (26 ページ), 消耗品の交換とクリーニング (22 ページ)

Fujitsu SCSI Scanner Installation Procedures

If you are installing the following models by means of the SCSI interface then please use this

document.

Fi-5530C2

Hardware requirements.

You will need a PC system that meets our recommended specifications, an appropriate SCSI

controller, and a SCSI cable (six foot recommended maximum). For recommended PC system

specifications and SCSI controllers please reference the

You may also need your Operating System Disk.

Step A: Installing the SCSI Host Adapter (Adaptec).

1. Shut down your PC and remove the case cover.

2. Locate a free PCI slot and remove the back plate if necessary.

3. Install the SCSI controller in an open PCI slot.

Make sure that the card is seated completely in the slot and secured in the frame

Warning! Failure to secure the SCSI controller in the PC can result in damage to the

SCSI card, scanner, and/or your system.

4. Boot your PC without the scanner attached

Step B: Installing the SCSI drivers (Adaptec).

5. When the New Hardware wizard comes up, allow Windows to finish installing the

hardware files for the SCSI controller.

6. Then either install/update the ASPI drivers from the CD or go to www.adaptec.com,

and click on the "search" tab.

7. For Windows 95\98 or ME scroll down to the "Enter key word or quoted phrase" box

and type in "aspi32".

8. Next scroll down to the drivers section, click on ASPI32 and follow the prompts to

download it your desktop or a new folder.

9. Afterwards go to that location and double click on the "aspi32.exe" icon and follow

the prompts.

10. When the message "ASPI is up to date" appears, reboot and go to the next step.

11. For Windows 2000 or XP scroll down to the "Enter key word or quoted phrase" box

and type in "aspi".

12. Next scroll down to the drivers section, click on ASPI_v470 or higher and follow the

prompts to download it.

13. Afterwards go to that folder and unzip the file to the default Adaptec\ASPI folder.

14. Then go to start, run, browse to the Adaptec\ASPI folder, select ASPIINST.EXE and

run it.

15. When the message "ASPI is up to date" appears, reboot and go to the next step.

Rev082708A

Windows 95\98\98SE\ME\2000\XP\Vista

Fi-6140

Fi-6240

Fi-6670\A

Fi-6770\A

Scanner Hardware Reference

page.

Page 1 of 1