- ページ 47
ソフトウェア Brother Quattro 6000DのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Brother Quattro 6000D 50 ページ。 Kit de actualización iii
Brother Quattro 6000D にも： マニュアル (42 ページ), 操作マニュアル (6 ページ), ユーザーマニュアル (48 ページ), 操作マニュアル (29 ページ), 操作マニュアル (21 ページ), (取扱説明書 (49 ページ), (取扱説明書 (21 ページ), (取扱説明書 (48 ページ)
ページを印刷する
Correcting Shrinkage
When created embroidery data is sewn, areas of the embroidery may shrink. If this occurs,
correct the shrinkage.
■ Shrinkage
The size of the pattern is enlarged and areas (fill stitches) shrink along the sewing direction.
Since areas shrink while lines (satin stitches) are sewn with the size before shrinking, the
lines and areas are no longer aligned.
In order to prevent this, adjust the length of the lines so that they are in the sewing direction
and are larger than the original data.
← Sewing direction →
Original data
←← Sewing direction →→
Adjusted data
Each arrow represents a shrinkage
adjustment value (0.1 mm increments)
1
Display in the pattern drawing screen the data with
shrunken areas, and then press
shown at the left appears.
2
Press
or
To lengthen the stitching, press
stitching, press
Each press of
mm.
Each press of
mm.
A setting between 0.0 mm and 2.0 mm in 0.1 mm
increments can be specified.
Notes
•
Normally, the default setting of 0.3 mm is used.
•
Continue sewing trial embroidery while making adjustments.
•
The larger the pattern size, the easier shrinkage will occur.
•
Shrinkage is also related to the sewing direction and stitch density
of the fill stitches. Also try adjusting these settings.
beside
.
. To shorten the
.
makes the stitching longer by 0.1
makes the stitching shorter by 0.1
. The screen
47