- ページ 25

マザーボード Fujitsu D1451のPDF テクニカル・マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu D1451 42 ページ。 Siemens

Add-on modules / Upgrading

Exit energy-saving mode, switch off the system and remove the power plug from the

mains outlet, before carrying out any of the procedures described in this chapter!

Even when you have switched off the device, parts (e.g. memory modules, AGP and PCI

extension boards) are still supplied with power.

Technical data

Intel Pentium 4 with 400 or 533 MHz front side bus in the mPGA478 design.

A current list of the processors supported by this mainboard is available on the Internet at:

www.fujitsu-siemens.de/mainboards.

Remove the fan that there may be and the heat sink.

Pull the lever in the direction of the arrow (1) and lift it as far as it will go (2).

Remove the old processor from the socket (3).

Insert the new processor in the socket so that the angled corner of the processor matches the

coding on the socket (A) with regard to the position (4).

The angled corner of the processor can also be at a different location than shown in the

illustration.

Push the lever back down until it clicks into place (5).

A26361-D1451-Z120-1-6319

Installing and removing processors

English - 15