- ページ 25

マザーボード Fujitsu D2530のPDF テクニカル・マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu D2530 35 ページ。 For econel 200 s2

Replacing the lithium battery

In order to save the system information permanently, a lithium battery is

installed to provide the CMOS-memory with a current. When the charge is too

low or the battery is empty, a corresponding error message is provided. The

lithium battery must then be replaced.

The lithium battery must be replaced with an identical battery or a battery

type recommended by the manufacturer (CR2032).

Do not throw lithium batteries into the trashcan. It must be disposed of in

accordance with local regulations concerning special waste.

Make sure that you insert the battery the right way round. The plus pole

must be on the top!

Figure 7: Replacing the lithium battery

Ê Press the locking spring into direction of of the arrow (1), so that the lithium-

battery jumps out of its socket.

Ê Remove the battery (2).

Ê Insert a new lithium battery of the same type into the socket (3) and (4).

D2530 (Econel 200 S2)

Technical Manual