- ページ 37

マザーボード Fujitsu D3030のPDF テクニカル・マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu D3030 38 ページ。 System board for bx920 s2

Replacing the lithium battery

In order to save the system information permanently, a lithium battery is

installed to provide the CMOS-memory with a current. When the charge is too

low or the battery is empty, a corresponding error message is provided. The

lithium battery must then be replaced.

CAUTION!

The lithium battery must be replaced with an identical battery or a battery

type recommended by the manufacturer (CR2450).

Do not throw lithium batteries into the trash can. Batteries must be

disposed of in accordance with local regulations concerning special

waste.

Make sure that you insert the battery the right way round. The plus pole

must be on the top!

Figure 12: Replacing the lithium battery

Ê Press the locking spring into direction of the arrow (1), so that the lithium

battery jumps out of its socket.

Ê Remove the battery (2).

Ê Insert a new lithium battery of the same type into the socket (3) and (4).

D3030 (BX920 S2)

Technical Manual