- ページ 11
マザーボード Fujitsu FLASH-CAN-48PのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu FLASH-CAN-48P 33 ページ。 F²mc-16lx family
ページを印刷する
3.2 Operating-Mode (S2)
The DIP-switch S2 is used to set the operating mode of the µC.
Ensure that the mode pin settings correspond to the operation-mode of the application.
For more detailed information please check the Hardware-Manual of the microcontroller.
DIP switch
S2/1 (MD0)
S2/2 (MD1)
S2/3 (MD2)
S2/4
S2/5
S2/6
S2/7 (P31)
S2/8 (P30)
Default: MD0, 1, 2 = 1 1 0 P30, P31 = 0 0
By default, the Single Chip Run-Mode is selected.
1
Note: *
Take care that the low-level is reached by the resistor-network N1 and the LEDs
D1/D2. In case that N1 is removed in order to free the Port, then P30 and P31
(MB90360/960 Series: P83 and P84) have to be connected manually to GND in case of
asynchronous programming (see chapter 4).
Dip-Switch S2
(default setting)
© Fujitsu Semiconductor Europe GmbH
FLASH-CAN-48P
Chapter 3 Jumpers and Switches
Setting
Logical value
ON (closed)
OFF (open)
ON (closed)
OFF (open)
ON (closed)
OFF (open)
not connected (OFF)
not connected (OFF)
not connected (OFF)
ON (closed)
OFF (open)
ON (closed)
OFF (open)
MD0 MD1 MD2 nc
1
2
3
4
- 11 -
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
1 (high)
1
0 (low)*
1 (high)
1
0 (low) *
nc
nc
P31 P30
P84 P83
ON
OFF
5
6
7
8
UG-900002-20