- ページ 19

マザーボード Fujitsu Siemens D1156のPDF テクニカル・マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu Siemens D1156 22 ページ。

Replacing the processor

Installing the processor

If you wish to upgrade your system with a new processor, the processor bracket on the

system board may need to be replaced beforehand. Should it be necessary to replace the

bracket, please contact our customer service center.

Depending on the design of the processor housing, the heat sink can be moved on the

processor and the processor in the bracket. This floating suspension in the installed state

ensures reliable contact between the processor and the heat sink. Detents in the bracket

prevent the processor from slipping out.

If the heat sink on the processor can be moved, then it must also be possible to move the

mounted processor in the bracket. This ensures optimum cooling.

If you replace the processor, grasp the processor housing by the processor and the heat

sink.

(A)

The illustration shows two bracket and processor models.

Remove the old processor if necessary.

Slide the processor into the bracket (1).

Push the processor down in the bracket and press it into the slot until the clamps (2) to the left

and right snap into place.

Set the clock frequency of the new processor using switches 5 to 8 of the switch block.

If the processor has a temperature sensor or a fan, attach the associated cable to the

connector for the temperature sensor or the fan on the system board.

Removing the processor

If the processor has a temperature sensor or a fan, pull out the associated cable.

Press the clamps (2) on either side of the processor slightly inwards (A) or outwards (B) and

pull the processor up and out. Use a screwdriver if necessary.

A26361-D1156-Z120-6-7419

(B)

Add-on modules

English - 11