- ページ 17
マザーボード Fujitsu SK-96620_350-64PMC(1)のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu SK-96620_350-64PMC(1) 47 ページ。 F²mc-16lx/fx family, mb96620/350 series, mb90350 series
ページを印刷する
4 Jumpers and Switches
Description of jumper settings
4.1 Introduction
This chapter describes all jumpers and switches that can be modified on the evaluation
board. The default setting of a jumper is highlighted by a grey shaded area. If the
settings depend on the microcontroller, then for each derivate a column with the respective
settings will be listed.
4.2 Operating-Mode (S2)
This switch controls the MCU operation mode after reset. Take account that in case of
MB966xx the MCU can be flashed via the debug tool MB2100-01-E and Softune
Workbench. In this case the MCU is in RUN mode. If a Serial Flash Programmer is applied,
please check for correct jumper settings noted below DIP switch settings (see Figure 4-1
and Figure 4-2).
Please take care of the following mode settings:
DIP switch
(MB966xx:DEBUG I/F
MB963xx /LX: MD0)
(MB966xx: P17_0,
MB963xx /LX: MD1)
(MB966xx: MD,
MB963xx /LX: MD2)
S2-7 (P00_1)
S2-8 (P00_0)
© Fujitsu Semiconductor Europe GmbH
SK-96620_350-64PMC(1) User Guide
Chapter 4 Jumpers and Switches
S2-1
ON (closed)
OFF (open)
S2-2
ON (closed)
OFF (open)
S2-3
ON (closed)
OFF (open)
S2-4
S2-5
S2-6
ON (closed)
OFF (open)
ON (closed)
OFF (open)
Table 4-1: MCU Operating Mode
Setting
Logical value
not connected (OFF)
not connected (OFF)
not connected (OFF)
- 17 -
0 (low)
1 (high)
0 (low)
1 (high)
0 (low)
1 (high)
1 (high)
0 (low)
1 (high)
0 (low)
UG-960028-12