- ページ 30

マザーボード Fujitsu SK-MB91590-208M04のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu SK-MB91590-208M04 35 ページ。 Fr family mb91590 series starter kit

8 Flash Programming of MCU

Please download and install the Flash Programmer from the following link:

http://mcu.emea.fujitsu.com/mcu_tool/detail/FLASH_PROGRAMMER_FR_FJ.htm

For programming the MCU the UART 'A' or USB 'A' can be used. Following the steps for

MCU flashing are listed:

1. The MCU can only get flashed via the MFS0 of the MCU. It is necessary to check the

jumper settings of JP28 and JP29 as follows.

Jumper

Setting

JP28

U-4 / R-0

(SIN)

JP29

U-4 / R-0

(SOT)

Table 22. Jumper Settings for Flash programming via UART 'A' (RS232)

Jumper

JP28

U-0 / R-4

(SIN)

JP29

U-0 / R-4

(SOT)

Table 23. Jumper Settings for Flash programming via USB 'A' (mini USB)

2. Install the newest FR Flash Programmer.

3. Connect the UART0 of the board via UART 'A' or USB 'A' connector to the PC.

4. Start the FR Flash Programmer.

5. Select the Target, Frequency and the (HEX)-File (.mhx) as the following picture

shows.

UG-910097-11

Chapter 8 Flash Programming of MCU

Description

USB 'A' (mini USB) connected to LIN-UART4 (SIN4)

UART 'A' (RS232/LIN) connected to MFS0 (SIN0)

USB 'A' (mini USB) connected to LIN-UART4 (SOT4)

UART 'A' (RS232/LIN) connected to MFS0 (SOT0)

Setting

Description

USB 'A' (mini USB) connected to MFS0 (SIN0)

UART 'A' (RS232/LIN) connected to LIN-UART4 (SIN4)

USB 'A' (mini USB) connected to MFS0 (SOT0)

UART 'A' (RS232/LIN) connected to LIN-UART4 (SOT4)

- 30 -