ページを印刷する
Personalisations
FUNCTION buttons
Setting the temperature
If, when the appliance is switched on, the KNOB is positioned on a programme for which the temperature
needs to be regulated, a fixed
programme set will be displayed and the
reaches OFF, which indicates a cold wash cycle (press it again to go back to the maximum value); stop on the
desired value, after approximately 2 seconds the setting is accepted: the symbol
The temperature adjustment is enabled with all wash programmes.
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.
If you set a function that is incompatible with another function you selected previously, only the last one
selected will be enabled.
Function
Effect
Bleaching cycle
designed to
Stain
remove the
removal
toughest stains.
Increases the
efficiency of the
Extra Rinse
rinse.
This option
reduces the
amount of
creasing on
fabrics, making
them easier to
Easy iron
iron.
Downloaded From WashingMachine-Manual.com Manuals
Setting the spin cycle
If, when the appliance is switched on, the KNOB is positioned
on a programme with a spin cycle, a fixed
button
programme set will be displayed, and the
it again and the values lower until they reach OFF, which
indicates that the spin cycle has been excluded (press it again
to go back to the maximum value); stop on the desired speed,
after approximately 2 seconds the setting is accepted: the
symbol
The spin cycle setting is enabled with all the programmes
except for 6 and the Draining cycle.
Setting the Delay Timer
Press the button
display, while the relative symbol flashes.
Press the button again and "1h" appears, that is, a delay of one
hour (this can reach up to 24h); stop on the "desired" delay;
after approximately 2 seconds the setting is accepted, following
which, the time for the set programme appears on the display
and the symbol
If you now press the START/RESET button, the set "delay"
appears; this decreases every hour until the start of the cycle.
In this phase, the "delay" can only be modified by decreasing it.
The Delay Timer regulation is enabled with all programmes.
appears. Press button
icon flashes. Press it again and the temperature lowers until it
Comments
Please remember to pour the bleach into extra compartment 4
(see page 20).
This function is incompatible with the EASY IRON function.
Recommended when the appliance has a full load or with large
quantities of detergent.
When this function is set, programmes 4, 5, 6 will end, with the
laundry left to soak (Anti-crease), and the relative button flashes:
- to conclude the cycle, press the START/RESET button or the
EASY IRON button;
- to run the draining cycle alone, set the knob to the relative
symbol
and press the START/RESET button.
This function is incompatible with the STAIN REMOVAL function.
and the maximum spin speed allowed for the
remains fixed.
and you will see the word OFF on the
remains on.
and the maximum temperature allowed for the
remains fixed.
GB
appears. Press
icon flashes. Press
Enabled with
programmes:
2, 3, 4,
Rinse cycle.
1, 2, 3, 4, 7,
8, 9, 11, 12,
Rinse cycle.
3, 4, 5, 6, 7, 8,
9, Rinse
cycle.
19