- ページ 9

冷蔵庫 Indesit BIAA seriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Indesit BIAA series 12 ページ。 Artica entry no frost fridge-freezer platform
Indesit BIAA series にも：取扱説明書 (8 ページ), 取扱説明書 (48 ページ), サービス・クイック・マニュアル (2 ページ), サービス・クイック・マニュアル (2 ページ)

ページを印刷する

Respecting and conserving the

environment

• Install the appliance in a fresh and well-ventilated room. Ensure

that it is protected from direct sunlight and do not place it near

heat sources.

• Try to avoid keeping the door open for long periods or opening

the door too frequently in order to conserve energy.

• Do not fill the appliance with too much food: cold air must

circulate freely for food to be preserved properly. If circulation is

impeded, the compressor will work continuously.

• Do not place hot food directly into the refrigerator. The internal

temperature will increase and force the compressor to work

harder and will consume more energy.

• Defrost the appliance if ice forms ( see Maintenance ). A thick

layer of ice makes cold transference to food products more

difficult and results in increased energy consumption.

• Regularly check the door seals and wipe clean to ensure they

are free of debris and to prevent cold air from escaping ( see

Maintenance ).

Troubleshooting

If the appliance does not work, before calling for Assistance (see

Assistance), check for a solution from the following list.

The internal light does not illuminate.

• The plug has not been inserted into the electrical socket, or not far

enough to make contact, or there is no power in the house.

The refrigerator and the freezer do not cool well.

• The doors do not close properly or the seals are damaged.

• The doors are opened too frequently.

• The TEMPERATURE ADJUSTMENT knob is not in the correct

position.

• The refrigerator or the freezer have been over-filled.

• The atmospheric temperature of the area surrounding the

appliance is lower than 14°C.

The food inside the refrigerator is beginning to freeze.

• The TEMPERATURE ADJUSTMENT knob is not in the correct

position.

• The food is in contact with the back inside wall of the refrigerator.

The AIR fan does not rotate

• The refrigerator door is open.

• The AIR system is only activated automatically when it becomes

necessary to restore perfect operational conditions inside the

refrigerator compartment.

The motor runs continuously.

• The door is not closed properly or is continuously opened.

• The outside ambient temperature is very high.

• The thickness of the frost exceeds 2-3 mm ( see Maintenance ).

The appliance makes a lot of noise.

• The appliance has not been installed on a level surface ( see

Installation ) .

• The appliance has been installed between cabinets that vibrate and

make noise.

• The internal refrigerant makes a slight noise even when the

compressor is off. This is not a defect, it is normal.

Some of the external parts of the refrigerator become hot.

• These raised temperatures are necessary in order to avoid the

formation of condensation on certain parts of the product.

The back wall of the refrigerator unit is covered in frost or

droplets of water

• This shows the appliance is operating normally.

There is water at the bottom of the refrigerator.

• The water discharge hole is blocked ( see Maintenance ).

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24