- ページ 13

食器洗い機 Indesit IDL 535のPDF 設置および使用マニュアルをオンラインで閲覧またはダウンロードできます。Indesit IDL 535 17 ページ。 Indesit dishwasher installation and use manual
Indesit IDL 535 にも：設置および使用マニュアル (17 ページ), 設置および使用マニュアル (16 ページ), マニュアル (17 ページ)

ページを印刷する

Electrical Connection

If your appliance is supplied with a 13 amp. fused plug it

can be plugged into a 13 amp socket for immediate use.

Before using the appliance please read the instruction below.

WARNING: THIS APPLIANCE MUST BE EARTHED.

THE FOLLOWING OPERATIONS SHOULD BE CARRIED OUT

BY A QUALIFIED ELECTRICIAN.

Replacing the fuse:

When replacing a faulty fuse, a 13 amp ASTA approved

fuse to BS 1362 should always be used, and the fuse cover

re-fitted. If the fuse cover is lost, the plug must not be used

until a replacement is obtained.

Replacemente fuse covers:

If a replacement fuse cover is fitted, it must be of the correct

colours as indicated by the coloured marking or the colour

that is embossed in words on the base of the plug.

Replacements can be obtained directly from your nearest

Service Depot.

Removing the plug:

Ifyour appliance has a non-rewireable moulded plug and

you should wish to remove it to re-route the mains cable

through partitions, units etc., please esure that either:

- the plug is replaced by a fused 13 amp re-wireable plug

bearing the BSI mark of approval

- or:

- the mains cable is wired directly into a 13 amp cable outlet,

controlled by a switch, (in compliance with BS 5733) which

is accessible without moving the appliance.

Disposing of the plug:

Ensure that before disposing of the plug itself, you make

the pins unusable so that it cannot be accidentally inserted

into a socket.

Instruction for connecting cable to an altenative plug:

Important: the wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow

- Earth

Blue

- Neutral

Brown

- Live

CAUTION:

Once the appliance has been installed, the electrical plug

and socket should remain accessible.

- If the power supply cable is damaged, it must be replaced

by the manufacturer or its Technical Assistance Service in

order to prevent all potential hazards. (See Assistance)

- The cable should not be bent or compressed.

- The Company shall not be held responsible for any incidents

that occur if these regulations are not observed.

As the colours of the wires in the mains lead may not

correspond with the coloured markings identifying the

terminal in your plug, proceed as follows:

connect Green & Yellow wire to terminal market "E" or

coloured Green or Green & Yellow.

Connect Brown wire to terminal marked "L" or coloured

Red.

Connect Blue wire to terminal marked "N" or coloured

Black.

If a 13 amp plug (BS 1363) is used it must be fitted with a

13 amp fuse. A15 amp plug must be protected by a 15

amp fuse, either in the plug or adaptor or at the

distribution board.

If you are in any doubt about the electrical supply to your

machine, consult a qualified electrician before use.

How to connect an alternative plug:

The wires in this mains lead are coloured in accordance

with the following code:

BLUE

BROWN

GREEN AND YELLOW

GREEN &

YELLOW

BROWN

BLUE

Disposing of the appliance:

When disposing of the appliance please remove the plug

by cutting the mains cable as close as possible to the plug

body and dispose of it as described above

"NEUTRAL" ("N")

"LIVE" ("L")

"EARTH" ("E")

13 amp fuse

CROSS-BAR

CORD GRIP