- ページ 20

オーブン Indesit KN6G21S/IのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Indesit KN6G21S/I 44 ページ。 Cooker and oven
Indesit KN6G21S/I にも：取扱説明書 (48 ページ)

ページを印刷する

Start-up and use

Using the hob

Lighting the burners

For each BURNER knob there is a complete ring

showing the strength of the flame for the relevant

burner.

To light one of the burners on the hob:

1. Bring a flame or gas lighter close to the burner.

2. Press the BURNER knob and turn it in an

anticlockwise direction so that it is pointing to the

maximum flame setting E.

3. Adjust the intensity of the flame to the desired level

by turning the BURNER knob in an anticlockwise

direction. This may be the minimum setting C, the

maximum setting E or any position in between the two.

If the appliance is fitted with an electronic lighting

when the knob is released. If this occurs, repeat the

operation, holding the knob down for a longer period of

time.

! If the flame is accidentally extinguished, switch off the

burner and wait for at least 1 minute before attempting

to relight it.

If the appliance is equipped with a flame failure

safety device*, press and hold the BURNER knob for

approximately 2-3 seconds to keep the flame alight

and to activate the device.

To switch the burner off, turn the knob until it reaches

the stop position

Practical advice on using the burners

For the burners to work in the most efficient way

possible and to save on the amount of gas consumed, it

is recommended that only pans that have a lid and a flat

base are used. They should also be suited to the size of

the burner.

WARNING! The glass lid can break in if

it is heated up. Turn off all the burners

and the electric plates before closing

the lid. *Applies to the models with glass

cover only.

device* (see gure), press the

ignition button, marked with

the symbol

, then hold the

BURNER knob down and turn

it in an anticlockwise direction,

towards the maximum flame

setting, until the burner is lit.The

burner may be extinguished

•.

To identify the type of burner, please refer to the

diagrams contained in the "Burner and nozzle

specifications".

! On the models supplied with a reducer shelf,

remember that this should be used only for the auxiliary

burner when you use casserole dishes with a diameter

under 12 cm.

Using the oven

! The first time you use your appliance, heat the empty

oven with its door closed at its maximum temperature

for at least half an hour. Ensure that the room is well

ventilated before switching the oven off and opening

the oven door. The appliance may emit a slightly

unpleasant odour caused by protective substances

used during the manufacturing process burning away.

! Never put objects directly on the bottom of the oven;

this will avoid the enamel coating being damaged.

Lighting the oven

To light the oven burner, bring

a flame or gas lighter close to

opening F (see gure) and press

the OVEN control knob while

turning it in an anticlockwise

direction until it reaches the

MAX position.

If the appliance is fitted with an electronic lighting

device* (see figure), simply press the OVEN control

knob and turn it in an anticlockwise direction, towards

the MAX position, until the burner is lit. If, after 15

seconds, the burner is still not alight, release the knob,

open the oven door and wait for at least 1 minute

before trying to light it again. If there is no electricity

the burner may be lit using a flame or a lighter, as

Only available in certain models.