- ページ 14
調理器 Indesit K3C11/FR SのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Indesit K3C11/FR S 24 ページ。 Cooker and oven
ページを印刷する
Installation
GB
! Before operating your new appliance please read
this instruction booklet carefully. It contains important
information concerning the safe installation and
operation of the appliance.
! Please keep these operating instructions for future
reference. Make sure that the instructions are kept with
the appliance if it is sold, given away or moved.
! The appliance must be installed by a qualified
professional according to the instructions provided.
! Any necessary adjustment or maintenance must be
performed after the appliance has been disconnected
from the electricity supply.
Positioning and levelling
! It is possible to install the appliance alongside
cupboards whose height does not exceed that of the
hob surface.
! Make sure that the wall in contact with the back of
the appliance is made from a non-flammable, heat-
resistant material (T 90°C).
To install the appliance correctly:
• Place it in the kitchen, the dining room or the bed-sit
(not in the bathroom).
• If the top of the hob is higher than the cupboards,
the appliance must be installed at least 200 mm away
from them.
HOOD
600
Min.
mm.
• Do not position blinds behind the cooker or less than
200 mm away from its sides.
• Any hoods must be installed according to the
instructions listed in the relevant operating manual.
Levelling
14
•
If the cooker is installed
underneath a wall cabinet,
there must be a minimum
distance of 420 mm
between this cabinet and
the top of the hob.
This distance should be
increased to 700 mm
if the wall cabinets are
flammable (see fi gure).
If it is necessary to level the
appliance, screw the adjustable
feet* into the places provided
on each corner of the base of
the cooker (see fi gure).
The legs* provided with the
appliance fit into the slots on
the underside of the base of the
cooker.
Electrical connections
Fitting the power supply cable
The cable should be suited to the type of electrical
connection used, according to the following connection
diagram:
400 3N
H05RR-F 5x2.5 CEI-UNEL 35363
H05VV-F 5x2.5 CEI-UNEL 35746
400V 2N
H05RR-F 4x4 CEI-UNEL 35363
H05VV-F 4x4 CEI-UNEL 35746
230V
H05RR-F 3x4 CEI-UNEL 35363
H05VV-F 3X4 CEI-UNEL 35746
To install the power supply cable correctly:
V
3
2
1
B
A
N
located in the lower area of the terminal board.
3. Position wires N and
(see fi gure) and perform the connection by tightening
the terminal board screws as much as possible.
4. Position the remaining wires on terminals 1-2-3 and
tighten the screws.
1
2
4
3
5
S
T
N
R
1
2
3
4
5
R
S
N
4
1
2
3
5
R
N
1. Loosen the screw V in
the terminal board and
pull the cover to open it
(see fi gure).
2. Position the connection
support A (see fi gure)
according to the
connection diagram
shown above. The
terminal board is
designed for single-
phase 230 V connection:
terminals 1, 2 and 3
are connected to each
other; jumper 4-5 is
according to the diagram