- ページ 9

調理器 Indesit K3G11/AUSのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Indesit K3G11/AUS 16 ページ。 Indesit cookers operating instructions

ページを印刷する

Start-up and use

Using The Hob

Lighting the burners

For each BURNER knob there is a complete ring

showing the strength of the flame for the relevant

burner.

To light one of the burners on the hob:

1. Bring a flame or gas lighter close to the burner.

2. Press the BURNER knob and turn it in an

anticlockwise direction so that it is pointing to the

maximum flame setting E.

3. Adjust the intensity of the flame to the desired

level by turning the BURNER knob in an

anticlockwise direction. This may be the minimum

setting C, the maximum setting E or any position in

between the two.

If the appliance is fitted with an electronic lighting

device* ( see figure ), press the ignition button,

1 1 1 1 1

marked with the symbol

knob down and turn it in an anticlockwise direction,

towards the maximum flame setting, until the burner

is lit. The burner may be extinguished when the

knob is released. If this occurs, repeat the operation,

holding the knob down for a longer period of time.

! If the flame is accidentally extinguished, switch off

the burner and wait for at least 1 minute before

attempting to relight it.

If the appliance is equipped with a flame failure

safety device*, press and hold the BURNER knob

for approximately 2-7 seconds to keep the flame

alight and to activate the device.

HOB GAS BURNER

SAFETY DEVICE

Check that the gas has been lit. If the burner fails to

ignite try again. If the burner fails to ignite after 3

attempts, wait a few minutes for the gas to disperse

before making any further attempts.

, then hold the BURNER

ELECTRONIC

LIGHTING DEVICE

If the burner still fails to ignite, a match or lighting

device can be used, but care must be taken. If the

problem persists, contact place of purchase or their

appointed agent for service.

If the flame has excessive yellowing, or appears to

lift off the burner ports, or makes a loud noise, turn

the burner off and call your service agent.

To switch the burner off, turn the knob until it

reaches the stop position •

Lighting the burners for the first time

If the appliance is being used for the first time, or if

it has not been used for a long period of time, it may

be necessary to purge the gas lines of excess air

before you can successfully light the burners.

To do this, turn each burner to High for 10-15

seconds and press the ignition button several times.

If the burner does not light, repeat this procedure

twice more. Wait 1-2 minutes for any gas build up to

disperse before allowing any further gas flow.

Practical advice on using the burners

For the burners to work in the most efficient way

possible and to save on the amount of gas

consumed, it is recommended that only pans that

have a lid and a flat base are used. They should

also be suited to the size of the burner.

To identify the type of burner, please refer to the

diagrams contained in the "Technical

specifications".

Do not use pans which are unstable or which have a

warped or damaged base.

Ensure the pot sits securely on the trivet and is

centred above the burner.

Burner

ø Cookware diameter (cm)

Fast (R)

Semi Fast (S)

Auxiliary (A)

* * * * *

Only available in certain models.

AUS

24 - 26

16 - 20

10 - 14