- ページ 26

調理器 Indesit KD3C1EのPDF 取付・使用説明書をオンラインで閲覧またはダウンロードできます。Indesit KD3C1E 32 ページ。 50cm free standing electric cooker

Care and Cleaning
Decorative Trims
Doors
Ovens
Oven Shelf Supports
26
It is advisable to clean the decorative trims regularly to prevent any build
up of soiling. The recommended method of cleaning is to wipe over the
trims with a soft cloth wrung out in warm water or mild non-abrasive
cleaner. (If in doubt try the cleaner on a small area of trim which is not
noticeable in normal use). Then, after wiping with a cloth wrung out in
clear water, dry with a soft clean cloth.
Wipe over the outer door glass panels with a cloth wrung out in warm soapy
water, then after wiping with a cloth wrung out in clear water, dry with a soft
clean cloth. Ensure that glass doors are not subjected to any sharp
mechanical blows.
Glass Inner Door Panel (where fitted) – open the door fully and unscrew the
two screws securing the glass panel, taking care not to allow the glass to fall.
The glass panel may now be washed at the sink. Stubborn stains can be
removed by using a fine steel wool soap pad. Ensure the glass panel is not
subjected to any sharp mechanical blows. Take particular care not to damage
the inner surface which is coated with a heat reflective layer. After cleaning, rinse
and dry with a soft cloth. For slight soiling the inner glass panel may be cleaned,
while still warm, without removing it from the door.
Warning: Oven must not be operated with inner door glass removed.
Take care during cleaning not to damage or distort the door seals. Do not lift
the door seal from the oven chassis, if necessary remove the seal by carefully
unhooking the corner clips.
Take care that the rating label edges are not lifted during cleaning, and
furthermore that the lettering is not blurred or removed.
Remove the rod shelves and grill pan.
Use a fine steel wool soap pad to remove stubborn stains from the
rod shelves, grill pan and the floor of the oven.
The shelf supports are removable and dishwasher safe.
To remove hold the support at the front and pull away from the oven
side, this can then be cleaned in a sink or a dishwasher.
When removed it allows access to the oven side, which can be cleaned
with warm soapy water.
To refit the support, insert the longer leg into the rear fixing hole and
push in the front leg.