- ページ 13

調理器 Indesit MVK6 V21 RFのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Indesit MVK6 V21 RF 24 ページ。 Cooker and oven

ページを印刷する

Installation

! Before operating your new appliance please read

this instruction booklet carefully. It contains

important information concerning the safe installation

and operation of the appliance.

! Please keep these operating instructions for future

reference. Make sure that the instructions are kept

with the appliance if it is sold, given away or moved.

! The appliance must be installed by a qualified

professional according to the instructions provided.

! Any necessary adjustment or maintenance must be

performed after the appliance has been

disconnected from the electricity supply.

We recommend cleaning the oven before

using it for the first time, following the

instructions provided in the "Care and

maintenance" section.

Positioning and levelling

! It is possible to install the appliance alongside

cupboards whose height does not exceed that of the

hob surface.

! Make sure that the wall in contact with the back of

the appliance is made from a non-flammable, heat-

resistant material (T 90°C).

To install the appliance correctly:

• Place it in the kitchen, the dining room or the bed-

sit (not in the bathroom).

• If the top of the hob is higher than the cupboards,

the appliance must be installed at least 200 mm

away from them.

HOOD

600

Min.

mm.

• Do not position blinds behind the cooker or less

than 200 mm away from its sides.

• Any hoods must be installed according to the

instructions listed in the relevant operating manual.

Levelling

If it is necessary to level the

appliance, screw the

adjustable feet* into the

places provided on each

corner of the base of the

cooker ( see figure ).

• If the cooker is

installed underneath a wall

cabinet, there must be a

minimum distance of 420

mm between this cabinet

and the top of the hob.

This distance should be

increased to 700 mm if

the wall cabinets are

flammable ( see figure ).

The legs* provided with the

appliance fit into the slots on

the underside of the base of

the cooker.

Electrical connection

Fitting the power supply cable

To open the terminal board:

• Insert a screwdriver into the side tabs of the

terminal board cover.

To install the cable, follow the instructions below:

• Loosen the cable clamp screw and the wire

contact screws.

! The jumpers are pre-set at the Factory for 230 V

single-phase connection ( see figure ).

230V ~

H05RR-F/ 3x4 CEI-UNEL 35363

H05VV-F/ 3x4 CEI-UNEL 35746

• To carry out the electrical connections as shown in

the figures, use the two jumpers inside the box

( see figure - labelled "P").

Only available in certain models.

• Pull the cover to

open it.