- ページ 5

ホブ Indesit 7HKEC 647 X RU/HAのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Indesit 7HKEC 647 X RU/HA 24 ページ。

ページを印刷する

1. Control Panel

Start-up and use

The glue applied on the gaskets leaves traces of

grease on the glass. Before using the appliance, we

recommend you remove these with a special non-

abrasive cleaning product. During the first few hours

of use there may be a smell of rubber which will

disappear very quickly.

A few seconds after the hob is connected to the

electricity supply, a buzzer will sound. The hob may

now be switched on.

- - - - -

+ + + + +

If the

button is pressed for an extended

period of time, the display scrolls quickly though the

power levels and timer minutes.

Switching on the hob

To switch the hob on, press and hold the

for approximately one second.

Switching on the cooking zones

Each cooking zone is controlled using a selector

button

and a power adjustment device

consisting of a double

• To begin operating a cooking zone, press the

corresponding control button and set the desired

power level (between 0 and 9) using the buttons

- - - - -

+ + + + +

and

Booster function*

The booster function for some of the cooking zones

may be used to shorten heating-up times. It may be

activated by pressing the

light directly above the button will illuminate. This

function boosts the power to 2000 W or 3000 W,

depending on the size of the relevant cooking zone.

The booster stops automatically after 4 minutes. While

the booster for one of the cooking zones is active, the

corresponding front or rear cooking zone will operate at

a reduced power level (e.g. if the booster for the rear

left-hand hotplate has been activated, the power level

of the front left-hand hotplate will be reduced). For

further information, please refer to the Technical

description of the models .

Only available in certain models.

button

- - - - -

+ + + + +

and

button.

button. The indicator

Booster

Switching off the cooking zones

To switch off a cooking zone, select it using the

corresponding selector button

- - - - -

• Press the

button: the power of the cooking zone

will progressively decrease until it is switched off.

Programming the cooking duration

! All the cooking zones may be programmed

simultaneously, for a duration between 1 and 99

minutes.

1. Select the cooking zone using the corresponding

selector button.

2. Adjust the power level.

3. Press the

programming button. The indicator

light corresponding to the selected zone will start

flashing.

4. Set the cooking duration using the

buttons.

5. Confirm by pressing the

selection occurs after 10 seconds.

The timer begins counting down immediately. A

buzzer sounds for approximately 1 minute and the

cooking zone switches off when the set programme

has finished.

Repeat the above procedure for each hotplate you

wish to programme.

Using multiple programmes and the display

If one or more hotplates are programmed, the

display will show the data for the hotplate with the

least time remaining, and the light corresponding to

the position of the hotplate will flash. The lights

corresponding to the other hotplates programmed

will be switched on.

To visualise the time remaining for the other

programmed hotplates, press the

repeatedly: the time remaining for

each hotplate will be shown

sequentially in clockwise order,

starting from the front left hotplate.

Changing the programme

1. Press the

button repeatedly until the duration

you wish to change is shown.

and:

- - - - -

+ + + + +

and

button or automatic

button