- ページ 13

ドライヤー Indesit EDPE 945 A2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Indesit EDPE 945 A2 16 ページ。

Delay Timer

The start of some programmes (see Programmes and options) may be delayed up to 24 hours. Before selecting a programme with

a delayed start make sure that the water bottle is empty and the filter is clean. The drum will rotate occasionally before the drying

programme starts to prevent the formation of creases.

Extra Care

This is a special option designed to gentle dry delicate clothes.

Press this button to select the low temperature setting; the light next to the button will switch on. Activating this option will increase

the duration of the cycles.

Energy Saver

An option designed to optimise the results when drying small loads (cotton loaded to a max. of 2 kgs. and synthetic

load to a max. of 1 kg.) thereby minimising consumption and drying times.

Memo

This option allows you to store your cycle selection along with any associated options and to easily use a previously stored cycle.

Delayed start options cannot be stored.

•Press and hold the button MEMO for 3 second to store a cycle. You can press this button when the desired cycle and associated

options have been selected either before the cycle has started or during the drying cycle. When you press and hold the Memo

button the LED flashes as well as the time on the display and after 3 second a beep will confirm that the details have been stored.

•To recall the stored cycle simply turn on the dryer, press the memo button and then start the cycle. It is possible to change any of

the options in the normal way. Every 2 minutes the stored cycle number will appear on the display. If no cycle has been stored you

will hear a beep when the Memo button is pressed.

•A stored programme can be overwritten with a new programme just by repeating the steps outlined above.

Key Lock

Keep this button pressed for a few seconds after choosing the programme and the desired options. When the warning

light is on, the other buttons and the knob are deactivated. To deactivate the block keep the button pressed and the

warning light goes off. The ON/OFF button switches off the machine even if the function lock button is active.

Not all options are available on all programmes (see Programmes and options).

Opening the door

If the door is opened (or the START/PAUSE button is pressed) while a programme is running, the dryer stops and the following may

occur:

• The START/PAUSE button flashes orange.

• When a delayed start is running, the delay countdown continues. It is necessary to press the START/PAUSE button to resume

the "Delay start" programme. The "Delay start" indicator light flashes and the display visualises the time remaining to the start of the

selected programme.

• It is necessary to press the START/PAUSE button to resume the programme. The progress indicator lights signal the running

phase and the START/PAUSE indicator light stops flashing and turns green.

• During the post anti-crease phase, the programme ends. Pressing the START/PAUSE button reactivates a new programme from

the

beginning.

• By turning the Programme selection knob, a new programme is selected and the START/PAUSE indicator light flashes green. This

procedure can be used to select the COOL drying programme to cool garments if they are judged to be dry enough.

Press the START/PAUSE button to start the new programme.

Heat Pump Protection System

The heat pump sytem has a compressor protection feature, that operates if you open the door or there is a power disruption or you

turn off the dryer. This system will prevent the heat pump compressor from starting for 5 minutes after the door is closed and the

programme started.

Note: If you have a power cut, switch off the power or remove the plug. When power is restored, plug in the machine, press and

hold the ON/OFF button until the dryer reactivates, then press Start/Pause button.