- ページ 14

冷凍庫 AEG ARCTISのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AEG ARCTIS 26 ページ。 Built-in fridge-freezers
AEG ARCTIS にも：取扱説明書 (32 ページ), 取扱説明書 (28 ページ), 取扱説明書 (40 ページ), 取扱説明書 (28 ページ), 操作説明 (16 ページ), 取扱説明書 (36 ページ), 取扱説明書 (36 ページ), 取扱説明書および設置マニュアル (28 ページ), 取扱説明書 (36 ページ), 取扱説明書 (27 ページ), 取扱説明書 (34 ページ), ユーザーマニュアル (24 ページ), 取付説明書 (11 ページ), 取扱説明書 (29 ページ), 取扱説明書 (23 ページ), 取付説明書 (25 ページ), 取付説明書 (24 ページ)

– if the storage temperature required has not yet been reached when

starting the freezer; if the storage temperature is no longer main-

tained (malfunction);

– after inserting fresh foodstuffs in a greater quantity than permitted

by the freezing capacity (see section on "Freezing");

– if the lid is left open too long.

You can switch off the warning buzzer with the WARNING OFF button.

The red warning light continues to flash until it is sufficiently cold

again inside the freezer.

The warning buzzer and red warning light are not triggered:

- if the power supply is interrupted;

– if the electronic thermostat is faulty.

Interior Accessories

Storage baskets

Fig. 4

Insert handles as shown in Fig. 4 if the basket is to be suspended on the

plastic cover frame on the upper edge of your chest freezer.

If baskets are to be placed in the chest freezer and stacked above each

other; the handles are to be folded inwards as shown in Fig. 5.

The handles then serve as a support for the basket to be placed on top.

Dividing partition

(Fig. 6)

The appliance is equipped with a removable dividing partition. With

the dividing partition you can divide the freezer into a large storage

section A and a smaller freezing section B (also see section on "Freez-

ing"). The dividing partition can additionally be used:

– for catching defrost water (see section on "Defrosting");

– as a freezing tray (e.g. for prefreezing berries).

For this purpose, the dividing partition can either be placed on the

bottom of the small freezing section B or put into a storage basket.

Please clean the appliance interior and all accessories prior to initial

start-up (see section: "Cleaning and Care").

Remove the ice packs - if they have been supplied with your model.