- ページ 10

冷凍庫 AEG SANTO C 7 14 40 iのPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。AEG SANTO C 7 14 40 i 14 ページ。 Integrating fridge freezer
AEG SANTO C 7 14 40 i にも：操作およびインストール手順 (29 ページ)

ページを印刷する

Ice pack

There is an ice pack in one drawer of the freezer.

In the event of a power failure or malfunction, the ice pack will lengthen

the amount of time it takes for the frozen food to become too warm by

several hours. The ice pack can only fulfil this task efficiently if it is placed

in the uppermost drawer, at the front, above the frozen food. You can use

the ice pack for cooling cold bags.

Preparation of Ice Cubes

Fill the ice cube tray 3/4 full with cold water, place it in the freezer com-

partment and leave to freeze.

To loosen the frozen cubes, either twist the ice cube tray or hold it under

running water for a few seconds.

Important! Never try to free an ice tray that is frozen to the freezer com-

partment using pointed or sharp edged objects. Use the ice scraper supplied.

Storage Goods Symbols/Freezing Calendar

• The symbols on the drawers show different types of frozen goods.

• The numbers indicate storage times

in months for the appropriate

types of frozen goods. Whether

the upper or lower value of the

indicated storage time is valid

depends on the quality of the

foods and pre-treating before

freezing. The lower value applies to

foods with high fat content.

Installation Location

This appliance should only be installed at a location where the ambient

temperature corresponds to the climate classification indicated on the rat-

ing plate, which is located on the inside left of the appliance.

The following table shows which ambient temperature is correct for each

climate classification.

Climate classification

The appliance should be located in a dry atmosphere, out of direct sunlight

and away from continuous heat and extreme temperature, e.g. not next to

a boiler or radiator, or in a very cold room e.g. an outhouse. If these tem-

peratures are exceeded i.e. warmer or colder, then the appliance may not

operate correctly.

For building-in and door reversal instructions please refer to the relevant

instructions on the following pages.

Your appliance needs air

For safety reasons, minimum ventila-

tion must be as shown Fig.

Attention: keep ventilation openings

clear of obstruction;

Reversing the door

The side the door opens can be changed from the right side (factory adjust-

ment) to the left side, if the installation site requires.

Warning! When changing the side the door opens, the appliance must not

be connected to the mains. Remove plug from the mains beforehand.

for an ambient temperature of

+10 to +32 °C

+16 to +32 °C

min.

50 mm

200 cm

min.

200 cm

D567