- ページ 19
冷凍庫 AEG SANTO C 7 18 41-4IのPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。AEG SANTO C 7 18 41-4I 28 ページ。 Integrating fridge freezer
AEG SANTO C 7 18 41-4I にも: 操作およびインストール手順 (15 ページ), 操作およびインストール手順 (29 ページ), 操作およびインストール手順 (28 ページ)

Positioning
This appliance should only be installed at a location where the ambient
temperature corresponds to the climate classification indicated on the rat-
ing plate, which is located on the inside left of the appliance.
The following table shows which ambient temperature is correct for each
climate classification.
Climate classification
The appliance should be located in a dry atmosphere, out of direct sunlight
and away from continuous heat and extreme temperature, e.g. not next to
a boiler or radiator, or in a very cold room e.g. an outhouse. If these tem-
peratures are exceeded i.e. warmer or colder, then the appliance may not
operate correctly.
For building-in and door reversal instructions please refer to the relevant
instructions on the following pages.
Your appliance needs air
For safety reasons, minimum ventila-
tion must be as shown Fig.
Attention: keep ventilation openings
clear of obstruction;
Reversing the door
The side the door opens can be changed from the right side (factory adjust-
ment) to the left side, if the installation site requires.
Warning! When changing the side the door opens, the appliance must not
be connected to the mains. Remove plug from the mains beforehand.
SN
N
for an ambient temperature of
+10 to +32 °C
+16 to +32 °C
19