- ページ 13

冷凍庫 AEG SCT71906S0のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG SCT71906S0 24 ページ。

Problem
The appliance is noisy.
Audible or visual alarm is on. The cabinet has been re-
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the COOLMATIC,
or after changing the tem-
perature.
Water flows inside the refrig-
erator.
Possible cause
The mains plug is not con-
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not sup-
ported properly.
cently switched on or the
temperature is still too
high.
The temperature in the ap-
pliance is too high.
The temperature in the ap-
pliance is too high.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The COOLMATIC is
switched on.
This is normal, no error has
occurred.
The water outlet is clog-
ged.
ENGLISH
Solution
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Door open alarm"or
"High temperature alarm".
Refer to "Door open alarm"or
"High temperature alarm".
Contact a qualified electrician
or contact the nearest Author-
ised Service Centre.
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "COOLMATIC ".
The compressor starts after a
period of time.
Clean the water outlet.
13