- ページ 17

換気フード AEG 240 DのPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。AEG 240 D 22 ページ。

• Screw the fuses back in or reset the automatic circuit breaker.

• Proceed as follows to reset the filter saturation display (counter):

Select any fan speed using E

the B

and F

them down for at least 3 seconds until the flashing letter C stops

being shown on the display (D) and then press the button B

The activated carbon filter display is now ready for use again.

Display warning on saturation of metal grease

filter

• After 30 operating hours the letter (F- grease filters) will flash on

and off on the display (D) in alternation with the fan speed setting.

• This means that the metal grease filters need to be cleaned! (This

operation should be carried out every 30 operating hours!).

• Proceed as follows to remove and clean the metal filters:

• Switch of the fan motor by pressing the button

• Take the precaution of removing the cartridge fuses from their fuse

holders or tripping the automatic circuit breaker to ensure the fan

motor cannot be switched on accidentally.

or F

buttons at the same time, continuing to hold

min

buttons and then press