ページを印刷する
4
www.aeg.com
The minimum distance between the hob surface on
•
which the pans stand and the lower part of the
appliance shall be at least 65 cm, unless otherwise
specified in the installation instructions for the
appliance or hob.
The discharge of air must comply with local authorities
•
regulations.
Ensure good air ventilation in the room where the
•
appliance is installed to avoid the backflow of gases
into the room from appliances burning gas or other
fuels, including open fires.
Make sure that the ventilation openings are not
•
blocked and the air collected by the appliance is not
conveyed into a duct used to exhaust smoke and
steam from other appliances (central heating systems,
thermosiphons, water-heaters, etc.).
When the appliance operates with other appliances
•
the maximum vacuum generated in the room should
not exceed 0.04 mbar.
Make sure not to cause damage to the mains cable.
•
Contact our Authorised Service Centre or an
electrician to change a damaged mains cable.
If the appliance is connected directly to the power
•
supply, the electrical installation must be equipped
with an isolating device that allows to disconnect the
appliance from the mains at all poles. Complete
disconnection must comply with conditions specified in
the overvoltage category III. The means for
disconnection must be incorporated in the fixed wiring
in accordance with the wiring rules.
Do not flambé under the appliance.
•
Do not use to exhaust hazardous or explosive
•
materials and vapours.
Clean the appliance regularly with a soft cloth to
•
prevent the deterioration of the surface material.
Do not use a steam cleaner, water spray, harsh
•
abrasive cleaners or sharp metal scrapers to clean the
surface of the appliance. Use only neutral detergents.