- ページ 8
配管製品 Kohler 10-Jet K-1000-H2のPDF ホームオーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Kohler 10-Jet K-1000-H2 48 ページ。 Tower custom hydro-massage system
Kohler 10-Jet K-1000-H2 にも: ホームオーナーズマニュアル (45 ページ)
![Kohler 10-Jet K-1000-H2 ホームオーナーズマニュアル](/uploads/products/server2/2555517/2555517.jpg)
FCC Compliance (cont.)
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and:
2. This device must accept any interference received, including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for compliance could void the
users authority to operate the equipment.
Care and Cleaning
Flushing Your Hydro-Massage System
Sanitize your hydro-massage system by flushing it twice a month or more, depending upon usage. To do
this:
Fill the footbath basin with hot water to a level 3" (7.6cm) above the top of the suction cover.
Add two teaspoons of low-foaming dishwasher detergent and 1/2 cup (115ml) of household bleach
to the water.
Run the hydro-massage system for 5 to 10 minutes in the waterfall mode followed by 5 to 10
minutes with all ten bodyjets running at the same time. Turn off the system and drain the water.
Fill the footbath basin with cold water to a level 3" (7.6cm) above the top of the suction cover. Run
the hydro-massage system for an additional 5 to 10 minutes in both the waterfall and ten bodyjet
modes. Drain the basin and wipe dry with a clean, soft cloth.
Cleaning the Exterior Surfaces
Use mild soap and water to clean the unit. Wipe the entire surface dry with a clean, soft cloth.
Many cleaners contain harsh chemicals, such as ammonia, which can adversely affect the finish and
are not recommended.
Do not use abrasive cleansers or solvents on the unit.
Cleaning the Walls and Basin
Various wall and basin materials require different cleaners and cleaning methods. Follow the care,
cleaning and maintenance instructions furnished by the wall and basin material suppliers and
manufacturers.
Cleaning the Door
For Kohler Door Enclosures:
Keep your door looking like new with a simple routine of daily care. Apply a glass cleaner with a
clean sponge and immediately rinse off the area with clean water.
Water conditions in various parts of the country will dictate any extra cleaning needed.
Kohler does not recommend the use of harsh abrasive chemicals. Harsh cleansers will damage the
metal and glass finish on your door.
Replace the seals when they show signs of wear, yellowing or leakage. For replacement parts, please
contact the dealer where you purchased the door enclosure.
For non-Kohler Door Enclosures:
Follow the care and cleaning instructions furnished by the door enclosure manufacturer.
1030200-5-A
8
Kohler Co.