- ページ 14

バスルーム設備 Kohler BELAY K-156T-LCPのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Kohler BELAY K-156T-LCP 23 ページ。

ページを印刷する

1. Installation Instructions

CAUTION: Risk of personal injury. To reduce

the risk of injury, people with infirmities should

not be allowed to use this product without close,

continuous supervision.

Use this bath only for its intended purpose as

described in this guide. Do not use attachments not

recommended by Kohler Co.

The bath must be connected only to a supply circuit

that is protected by a Residual Current Device

(RCD). Such a RCD should be provided by the

installer and should be tested on a routine basis. To

test the RCD, press the test button. The RCD

should interrupt power. Press the reset button.

Power should be restored. If the RCD fails to

operate in this manner, the RCD is defective. If the

RCD interrupts power to the bath without the test

button being pressed, a ground current is flowing,

indicating the possibility of an electric shock. Do not

use this bath. Disconnect the bath and have the

problem corrected by a qualified service

representative before using.

Flush your whirlpool system twice a month or more

depending upon usage, as described in the "Flush

the System" section of this guide.

Do not operate this unit without the guard (cover)

over the suction fitting.

Repeated use of personal care products containing

oils can damage plastic whirlpool components.

Avoid using bath oils.

Whirlpool hydro-massage action can cause even a

small amount of bubble bath, bath soap, shampoo,

or bath oil to foam excessively. For this reason,

please do not use these products during whirlpool

operation.

OPERATING THE AIR SYSTEM

NOTE:

This is a combination airbath and whirlpool

bath, and includes a heated back surface. For

information on using the whirlpool features, refer to the

"Operating the Whirlpool System" section. Refer to the

"Operating the Heated Surface" section to use the

heated surface feature.

NOTE:

If the unit does not function properly, please

refer to the "Troubleshooting" section.

Before entering the bath, make sure the seal is free

of dirt and debris.

Enter the bath, then close and latch the door.

Use your hand to test the water temperature before

closing the drain and filling the bath.

Fill the bath at least 4" (102 mm) above the top of

the airjets.

Press the three-speed air system button once to

start the air system at high speed.

Press the air system button a second time to

operate the air system at medium speed.

1397340-T01-A

RCD

-14-

(RCD)

RCD

4" 102 mm