- ページ 16
バスルーム設備 Kohler BELAY K-23769T-RCPのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Kohler BELAY K-23769T-RCP 23 ページ。
ページを印刷する
Error Codes
·
Heat indicator blinking red - The heater is not
functioning.
·
Heat indicator blinking yellow - The temperature
sensor is not functioning or is loose.
·
Refer to the "Troubleshooting" section to
troubleshoot any problems.
Confirm Heated Surface Operation
NOTICE: When testing the heated surface functions,
allow 5 to 10 minutes to begin feeling heat on the end
wall.
·
Press the [Power] icon on the user keypad.
·
Observe that the heat indicator turns yellow and the
heater produces low heat.
·
Press the [Up] arrow. Verify that the heat indicator
turns orange and the temperature increases.
·
Press the [Up] arrow a second time. Verify that the
heat indicator turns red and the temperature
increases.
·
Press the [Down] arrow. Verify that the heat
indicator turns orange and the temperature
decreases.
·
Press the [Down] arrow a second time. Verify that
the heat indicator turns yellow and the temperature
decreases.
·
Press the [Power] icon to turn the heater OFF.
OPERATING THE WHIRLPOOL SYSTEM
NOTE: This is a combination whirlpool and airbath, and
includes a heated back surface. For information on
using the airbath features, refer to the "Operating the
Air System" section. Refer to the "Operating the Heated
Surface" section to use the heated surface feature.
Start/Stop the Whirlpool Jets
·
Enter the bath, then close and latch the door.
·
Position the jet nozzles downward and turn the jet
trim rings fully counterclockwise.
·
Use your hand to test the water temperature before
closing the drain and filling the bath.
1397340-T01-A
Heat/Temperature Indicator
/
Power On/Off
/
·
·
·
·
·
·
[
]
·
[
]
·
[
]
·
[
]
·
[
]
Increase Temperature
Decrease Temperature
/
·
·
·
-16-
-
-
5-10
[
]