- ページ 13
バスルーム設備 Kohler C3-430のPDF ホームオーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Kohler C3-430 32 ページ。 Nightlight heated elongated cleansing toilet seat
Kohler C3-430 にも： 取付説明書 (45 ページ), インストレーション・マニュアル (16 ページ), ホームオーナーズマニュアル (39 ページ), マニュアル (2 ページ)
ページを印刷する
Maintenance in case of long-term idle status
If the bidet seat will be idle for a long term or if the ambient temp may drop below
¨
the freezing point, please disconnect the power plug, turn off the angle valve, re-
move the water inlet hose and drain the water in it.
Befor resuming using after a long term, please wash it several times and make sure
¨
that the internal pipeline is clean.
Troubleshooting
This troubleshooting guide is for general aid only. A Kohler Authorized Service Repre-
sentative or qualified electrician should correct any electrical problems. For warranty
service, contact your dealer or wholesale distributor.
General Functions
Phenomenon
1. Funtions are not
working.
2. Seat is loose or
moves.
3. No water comes out
of the nozzle.
4. No water flow.
Kohler Co.
Probable Causes
A. Power failure occurred.
B. The power cord is discon-
nected.
C. Ground-Fault Circuit Interrupt
(GFCI) may be tripped.
D. The seat fails to detect user.
E. Thermal protector to open
automatically to protect.
F. None of the above
solutions take effect
A. Screws and nuts are loose.
A. Seat does not detect user.
B. Water supply stop closed.
C. Filter is clogged.
D. None of the above actions
correct the symptom.
A. The water supply valve is
turned off.
B. The seat-on sensor fails to
detect the user.
13
Recommended Action
A. Wait until the power is restored.
B. Insert the power cord into an
electrical outlet.
C. Reset the GFCI and locate the
problem.
D. You have to sit inside the seat
sensing area.
E. Allow the seat to cool to room
temperature.
F. Contact a KOHLER Service
Representative.
A. Tighten the screws and nuts
according to the installation guide.
A. Sit on the seat.
B. Power off, remove water supply
fault and power on again.
C. Refer to "CLEAN FILTER" section
D. Contact a KOHLER
Service Representative.
A. Open the water suply valve.
B. Check how to activate the seat in
the "INSTALLATION INSPEC-
TION" section of the "instalation
Guide."
1349981-X5-A