- ページ 10

バスルーム設備 Kohler K-1106のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler K-1106 44 ページ。 Bath whirlpool
Kohler K-1106 にも：ホームオーナーズマニュアル (32 ページ), ラフイン・マニュアル (4 ページ), インストレーション・マニュアル (48 ページ), ラフイン・マニュアル (4 ページ), インストレーション・マニュアル (44 ページ), インストレーション・マニュアル (48 ページ)

Make sure air actuator tubing is

securely attached to the pump.

Bond in accordance with applicable codes.

NOTE: Pump model illustrated may differ from your

actual product.

8. Make Electrical Connections

WARNING: Risk of electrical shock. To reduce the risk of electrical shock, connect the pump to a

properly grounded Ground-Fault Circuit-Interrupter (GFCI). This will provide additional protection

against line-to-ground shock hazard. A 120 V, 15 A dedicated circuit is required.

WARNING: Risk of electrical shock. Make sure the power has been disconnected before performing

the following procedures.

Locate and secure the supplied junction box a minimum of 1-1/2" (3.8 cm) above the subﬂoor.

The whirlpool controls and system have been prewired at the factory. A licensed electrician should

make a routine service connection to the junction box.

Connect service to the junction box. The 60 Hz model junction box contains black and white wires

and a ground lug.

A 120 V, 15 A dedicated circuit is required. Provide a Class A Ground-Fault Circuit-Interrupter

(GFCI).

Provide a separate equipment grounding conductor for the inside ground or ground lug. The

conductor must not be connected to any current-carrying conductor.

Bond in accordance with national and local codes.

1010914-2-D

Pump

Electrical

Cord

Junction box should be

wired as shown.

Ground

Neutral

(White)

Electrician to

provide suitable

Neutral

strain relief.

Wire Connectors

From Pump

Line

(Black)

Line

Kohler Co.