- ページ 13

ドライヤー AEG 9000 SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG 9000 Series 48 ページ。
AEG 9000 Series にも：ユーザーマニュアル (32 ページ), ユーザーマニュアル (8 ページ)

Make sure that the drain

hose end is not immersed in

the water. There may be a

return of dirty water into the

appliance.

3. To a stand pipe with vent-hole -

Insert the drain hose directly into a

drain pipe. Refer to the illustration.

The end of the drain hose

must always be ventilated ,

i.e. the inner diameter of the

drain pipe (min. 38 mm -

min. 1.5") must be larger

than the external diameter of

the drain hose.

4. If the end of the drain hose looks like

this (see the picture), you can push it

directly into the stand pipe.

5. Without the plastic hose guide, to

a sink spigot - Put the drain hose in

the spigot and tighten it with a clamp.

Refer to the illustration.

Make sure that the drain

hose makes a loop to

prevent particles going into

the appliance from the sink.

6. Position the hose directly to a built-

in drain pipe in the room wall and

tighten it with a clamp.

5.6 Electrical connection

At the end of installation you can connect

the mains plug to the mains socket.

The rating plate and the 'Technical Data'

chapter indicate the necessary electrical

ratings. Make sure that they are

compatible with the mains power supply.

Check that your domestic electrical

installation can take the maximum load

required, also taking into account any

other appliances in use.

Connect the appliance to an earthed

socket.

ENGLISH