- ページ 10

バスルーム設備 Kohler K-12108のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler K-12108 36 ページ。 One-piece barrier-free shower modules
Kohler K-12108 にも：ホームオーナーズマニュアル (8 ページ)

ページを印刷する

Install the Plumbing (cont.)

Provide access at the back of the plumbing wall to make drain connections to the receptor.

Install the shower valving according to the manufacturer's instructions. Do not install the trim at

this time.

4. Prepare the Module

CAUTION: Risk of property damage. Make sure a watertight seal exists around the drain. If a

watertight seal on the drain is not obtained, water damage to the subﬂoor may occur.

Install the drain to the module according to the drain manufacturer's instructions.

Layout and mark the location of the mixing valve, shower, and the bath spout holes on the back

surface of the module wall.

NOTE: If the supply ﬁttings have been located accurately during rough ﬁtting, a pilot hole template can be

used for multiple installations. Make a pilot hole template of lightweight plywood. Use the pilot hole

template to mark ﬁtting locations on the back side of the module.

Drill 1/4" (6 mm) pilot holes at the marked locations.

Clean the module to reduce the risk of surface damage.

Place a clean drop cloth or other similar material into the bottom of the module.

From the inside of the module (ﬁnished surface), use a hole saw of the correct diameter to carefully

drill the ﬁtting holes.

Clean any debris from the module to reduce the risk of surface damage. Be careful not to scratch the

surface of the unit.

1030529-2-B

Kohler Co.