- ページ 3

バスルーム設備 Kohler K-12109のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler K-12109 36 ページ。 One-piece barrier-free shower modules
Kohler K-12109 にも：ホームオーナーズマニュアル (8 ページ)

ページを印刷する

Before You Begin (cont.)

Before installation, provide access at the back of the plumbing wall. Because the module is

one-piece, the drain and overﬂow connections cannot be made by reaching over the end of the

module.

Make sure the installation area is clean and free of all debris. If remodeling, remove all ﬁnished wall

material to expose the framing and remove all ﬂoor coverings to expose the subﬂoor.

Consult all applicable instructions for options and accessories before beginning this installation.

Fixture conforms to ANSI Standard Z124.2. All dimensions are nominal.

Kohler Co. reserves the right to make revisions in the design of products without notice, as speciﬁed

in the Price Book.

Roughing-In Provisions

IMPORTANT! All dimensions are nominal. The stud opening tolerance is +1/4" (6 mm)/-0. Carefully

measure your ﬁxture before determining enclosure size. Some shimming between the stud frame and the

ﬁxture may be required. If a ﬁrewall is required, rough-in dimensions will have to increase according to

the thickness of the ﬁrewall material. Stud opening dimensions must be measured toward the exposed

side of the wall material. When a ﬁre-rated wall is speciﬁed, dimensions are to the inside of the wall

board. Dimensions given in the rough-in information are crucial for proper installation. Construct the

framing and plumbing accurately.

NOTE: The basin area requires no additional support when the subﬂoor is level and square with respect to

the framing. Consider using shims for additional support if the subﬂoor is uneven.

ADA Provisions

These models comply with the Americans with Disabilities Act when installed per the requirements

of the Accessibility Guidelines, Section 4.21 Shower Stalls, of the Act. Consider the user's physical

limitations when determining the position of the module and the location of the shower control

area(s). To ensure ADA compliance, position the module exactly as shown in the roughing-in

diagram. Locate the shower control areas as illustrated.

Provide clear ﬂoor space according to the roughing-in illustrations. You can provide the clear ﬂoor

space with either a front or side user access. Consider the path of the wheelchair user when

building the clear ﬂoor space. Be sure there is sufficient room for a wheelchair user to enter the

room and maneuver the wheelchair to the module.

When possible, a side entrance to the module should be employed to ensure the easiest wheelchair

accessibility.

If the user will have caregiver assistance, we recommend using a front entrance.

Kohler Co.

1030529-2-B