- ページ 29
ドライヤー AEG LAVATHERM 59840のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG LAVATHERM 59840 48 ページ。 Condenser dryer with heat pump
ページを印刷する
Displayed programme time
changes erratically or stays un-
changed for a long time.
Programme inactive, empty
water tank
Drying cycle ends shortly after
programme starts. END display
illuminated.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends
automatically (see „Drying cy-
cle complete ").
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can
be obtained from the Customer Care Department, ET no. 112 552 000-5.
When the appliance is switched on, the interior lighting switches itself off after 4
minutes when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the
machine!
WARNING!
Before replacing the bulb, disconnect the mains plug.
1. Unscrew cover above the bulb (this can be found directly behind the loading
aperture, at the top; refer to "Description of machine" section.)
Defective light bulb.
Programme time is corrected
automatically depending on
type and volume of laundry
and level of dampness.
Condensate tank is full.
icon is on.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room
temperature. Temporary
switching off of the compres-
sor to avoid overload.
What to do if ...
Replace light bulb (see next
section).
Automatic process; this is not a
machine fault.
Empty condensate tank, then
start programme with START
PAUSE button.
Select time programme or
higher drying level (e.g. INTEN-
SIVE DRY instead of STORAGE
DRY).
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately
spun.
Automatic process, there is no
fault with the appliance. If pos-
sible, lower the room tempera-
ture.
29