- ページ 11

ドライヤー AEG LAVATHERM 65170AVのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG LAVATHERM 65170AV 20 ページ。
AEG LAVATHERM 65170AV にも：ユーザーマニュアル (27 ページ), ユーザーマニュアル (40 ページ)

ページを印刷する

1. Troubleshooting

8.1 Adjustment of the

remaining laundry moisture

degree

To change the default degree of the

remaining moisture of the laundry:

1. Use the programme knob to set any

programme.

2. Wait approximately 8 seconds.

3. Press and hold buttons (A) and (D) at

the same time.

One of the these indicators comes on:

• End - the maximum dry laundry

• Cooling - the more dry laundry

9. BEFORE FIRST USE

Before you use the appliance for the first

time do these operations:

• Clean the tumble dryer drum with a

moist cloth.

10. DAILY USE

10.1 Start a programme

without delay start

1. Prepare the laundry and load the

appliance.

CAUTION!

Make sure that when you

close the door, the

laundry does not catch

between the appliance

door and the rubber

seal.

2. Set the correct programme and

options for the type of load.

3. Press the Start/Pause touchpad.

The programme starts.

10.2 Starting the programme

with delay start

1. Set the correct programme and

options for the type of load.

2. Press the delay start button again

and again as necessary.

You can delay the start

of a programme by 3, 6

or 9 hours.

3. Press the Start/Pause button.

• End and Cooling the standard dry

laundry

4. Press the button (E) again and again

until the indicator of the correct level

comes on.

5. To confirm the adjustment, press and

hold buttons (A) and (D) at the same

time for approximately 2 seconds.

8.2 Buzzer permanent off

To deactivate or activate the acoustic

signals, press and hold for approximately

2 seconds touchpads (A) and (B) at the

same time.

• Start a short programme (e.g. 30

minutes) with moist laundry.

The LEDs (9H, 6H, 3H) change on each 3

hours.

10.3 Change a programme

1. Turn the Programme knob to

2. Set the programme.

10.4 At the end of the

programme

When the programme is completed:

• An intermittent acoustic signal

operates (If the Buzzer function is on).

• The indicators End and Filter comes

on.

• The Start/Pause indicator is on.

The appliance continues to operate with

the crease guard phase for

approximately other 30 minutes.

The crease guard phase removes creases

from your laundry.

You can remove the laundry before the

crease guard phase is completed. We

recommend, for better results, that you

remove the laundry when the phase is

almost completed or completed.

ENGLISH

OFF