ページを印刷する
24
www.aeg.com
Problem
Unsatisfactory
drying result.
The loading
door does not
close
It is not possible
to change the
program or op‐
tion.
It is not possible
to select an op‐
tion. An acoustic
signal is emit‐
ted.
Unexpected du‐
ration time ap‐
pears on the
display.
A program is in‐
active.
Possible cause
Incorrect program selection.
The filter is clogged.
Dryness Level option was set to
3)
Iron Dry .
The load was too large.
The airflow slots are clogged.
There is some dirt on the humidity
sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi‐
tion.
Laundry is trapped between the
door and the seal.
After a cycle starts it is not possi‐
ble to change the program or op‐
tion.
The option you tried to select is not
available for the selected program.
The drying duration is calculated
according to load size and damp‐
ness.
The water container is full.
Remedy
Select a suitable program.
2)
Clean the filter.
Change Dryness Level option to a
higher level.
Do not exceed the maximum load
size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct position.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the program or option as
required.
Turn the tumble dryer off and on.
Change the program or option as
required.
This is automated - the appliance
is working correctly.
Drain the water container, push the
2)
Start/Pause button.
1)
4)
2)