- ページ 9

バスルーム設備 Kohler Sterling 71040110のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Kohler Sterling 71040110 44 ページ。 Baths, afd baths, and wall surrounds

4. Secure the Bath to the Framing

Secure the Bath to the Studs

NOTE: If your bath is shipped with a liner, keep the liner in place until construction is complete. If a liner

is not available, place a clean drop cloth or similar material in the bottom of the bath.

NOTE: The bath can be attached to the studs using attachment clips (provided) or large-head rooﬁng nails.

Verify that the studs are within 1/8" (3 mm) of the bath at the recommended attachment clip or nail

locations. Shim if necessary.

Verify that the fastener heads will not interfere with installing the wall surrounds or ﬁnished wall

material.

To secure attachment clips to the studs:

Refer to the "Roughing-In" section for attachment clip locations.

Position the bottom lip of the attachment clip under the bath ﬂange as shown in the illustration.

Slide the attachment clip into place between the center of the stud and the bath.

Bend the attachment clip tab over the bath ﬂange with a pair of pliers.

Secure the clip with a large-head rooﬁng nail or non-tapered ﬂathead screw.

To secure large-head rooﬁng nails to the studs:

IMPORTANT! Install the large-head rooﬁng nails directly above the bath ﬂange at each stud location. Do

not nail or drill through the bath ﬂange.

Install the nails so the nail heads will secure the bath ﬂange without damaging it, and will not

interfere with installing the remaining wall material.

Sterling

Bath Flange

Stud

Nail

Attachment

Clip

Bath

Roofing Nail

Wall Stud

1015404-2-D