- ページ 3

バスタブ Kohler Englefield Studio II 1700 FSのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Kohler Englefield Studio II 1700 FS 4 ページ。

Kohler Englefield Studio II 1700 FS インストレーション・インストラクション
FREESTANDING BATHS
Recommended products are:
Product
40mm pop-up bath waste
Self-sealing trap with flexible waste pipe
5) Raise the Free Standing bath off the floor by propping it up onto timber blocks
positioned at either end of the bath. Install and connect the waste outlet.
6) Adjust the feet so that the bottom of each foot is protruding approximately 3 to 5mm from
the underside of the bath. The feet must extend past the bath shell to take the weight
of the bath. Feet should be level with each other so that the weight of the bath is evenly
supported by the four feet.
7) Carefully remove the timber blocks and use a spirit level to check that the bath is level
with the floor, adjust feet as necessary.
8) Carefully tilt the bath backward and apply an appropriate adhesive to each of the bath
feet. Lower the bath back into position.
INSTALLATION INSTRUCTIONS
Page 2
Part Number
99329A-CP
80144A-NA
ENGLEFIELD